NP2-120 Northstar 120 VAC full featured inductive Vehicle Loop Detector

• Easy to install via 11 pin plug-in connector
• Replace old or damaged detectors in seconds
• Ready to use right out of the box. No re-wiring needed!

Ideal Applications:

• car wash entry & exit door triggering
• industrial dock doors
• parking lot in and out gate control
• parking lot automation
• drive-thru monitoring
• security presence alert, for example car at location, fork lift at pick up dock
• access control signaling, signals lights or horns
• vehicle or fork lift counting

Supply Voltage: 110 to 130 VAC 50/60 Hz

Sarasota / Peek Traffic 625X Users: plug-in replacement & upgrade for the following Sarasota / Peek Traffic models: 625X-120VAC, 625X-110VAC & 625X-120V/PP detectors.

Features:

• Easy to use controls
• 10 selectable sensitivities (factory setting is 5 or medium, good for most applications)
• Works with any in-ground or surface mounted inductive loop from 20 to 1500 µH
• Four selectable operating frequencies ( factory setting is set to HI)
• Failsafe or failsecure options
• Second relay output mode selectable
• Loop failure indicator for both open or shorted loops
• Permanent presence switch selectable (factory setting is set to 60 minutes)

Overview:

• Full featured inductive vehicle detector by Northstar Controls LLC
• With its front & rear panel switch features, the NP2 is the most `user friendly` detector on the market today
• It's the only vehicle / parking detector you will ever need!
• This device is also known as an inductive loop sensor or inductive loop detector.
• Made in the USA